Berzin
Posts:76
|
08/14/2020 02:20 PM |
|
I made a few mistakes when ordering my time trial frame a few years ago that I'm looking to rectify. I'm sending the aluminum frame back to Cyfac to replace the head tube from a one inch utilizing a regular headset to a one and 1/8th or 1/8 to 1/1.5 with a hidden headset and possibly run internal cables.
I have a one inch 3T A-Hero aero handlebar that I'm not looking to replace, but I will need to retro fit it so it can fit a 1 and 1/8 fork. Can this be done, and more importantly, where do I take it to get it done?
I've been watching too many restoration videos on youtube, and it's convinced me that anything can be fixed and that nothing is impossible. I see this as falling into that category. |
|
|
|
|
Cosmic Kid
Posts:4209
|
08/14/2020 04:08 PM |
|
I would seriously advise against that....you would essentially have to bore out material that was designed to be there and could well be structural...or at least lead to a a significant weakening of the stem that would lead to failure. I have never seen anyone advise doing this, either when actually working with component manufacturers directly or in common usage. Just get a new bar...much cheaper than having your teeth replaced. |
|
Just say "NO!" to WCP!!!!
|
|
|
Berzin
Posts:76
|
08/16/2020 05:52 PM |
|
I was thinking maybe of expanding the particular area from 1 inch to 1 and 1/8th or having someone weld one in place that fits. |
|
|
|
|
Cosmic Kid
Posts:4209
|
08/16/2020 07:41 PM |
|
If you expand it, you won’t get even clamp force and the bolt holes won’t line up. I can’t say for sure on welding on a new one, but IIRC, re-welding aluminum doesn’t work because of hiw aluminum is treated to finish it. And the money you would spend on that would likely cost more than a new stem / bar. A Zipp Alumina Vuka base bar is ~$80, I think and is a great bar. Get a generic stem from your LBS for a few bucks and you have a pretty cheap solution. |
|
Just say "NO!" to WCP!!!!
|
|
|
Berzin
Posts:76
|
09/15/2020 01:30 PM |
|
I'm pretty much set on having an integrated bar/stem setup. I have found the Vision Metron TFA to my liking so I'll see about getting my hands on those. Either that or I'll scour Ebay when I get the frame back from Cyfac. As long as I can find something that has a 1 and 1/8th compatible stem I'll be happy, just didn't want to get rid of a perfectly good TT handlebar that still looks kickass even after so many years. |
|
|
|
|