October 31, 2014 Login  


sram gxp bottom bracket
Last Post 07/22/2013 10:25 AM by carl x. 3 Replies.
Printer Friendly
Sort:
PrevPrev NextNext
You are not authorized to post a reply.
Author Messages
THE SKINNY

Posts:413

--
07/18/2013 02:07 PM
i ordered a new sram gxp bottom bracket to replace my old one that was getting noisy. it's the kind with the external bearings with the plastic tube that runs between them. anyway, i removed the old one and installed the new one no problem. while putting the cranks back on, the spindle wouldn't fit all the way into the drive side bearing. looking at the bearing there's a dust cover that fits the face of the bearing but also fits inside the hole that the spindle fits in making it to small for the spindle. the cover comes right off so i removed it and installed the cranks. is the dust cover necessary? did i completely screw it up?
How we spend our days is, of course, how we spend our lives.
jrt1045

Posts:362

--
07/19/2013 11:10 AM
its a tight fit, i usually pull it out and slide it over the spindle first before installing. As long as its going the right direction all is good. Its job is to keep the bearings from being exposed directly to the elements
THE SKINNY

Posts:413

--
07/19/2013 12:10 PM
i don't see it fitting but i'll try it when i get home.
How we spend our days is, of course, how we spend our lives.
THE SKINNY

Posts:413

--
07/22/2013 10:25 AM
got it. the old one was still stuck on the spindle. what a goofball.
How we spend our days is, of course, how we spend our lives.
You are not authorized to post a reply.

Active Forums 4.1

Latest Forum Posts

SS Beard posted in The Coffee Shop

A hit and run and probable fatality posted in The Coffee Shop

bottom bracket clicking posted in Gear Advice

New Hour Record Attempt - On now!! posted in Professional Racing

New Team Rosters posted in Professional Racing

Damn chip seal! posted in Road Cycling

No articles match criteria.
  Terms and Conditions | Privacy Policy  Copyright 2008-2013 by VeloNation LLC