October 25, 2014 Login  


A nice finish to teh Zipp question
Last Post 09/17/2013 01:11 PM by Garret Janney. 0 Replies.
Printer Friendly
Sort:
PrevPrev NextNext
You are not authorized to post a reply.
Author Messages
GJanney

Posts:76

--
09/17/2013 01:11 PM
So in a previous thread, I talked about low tension in my rear wheel (Zipp 404 Clincher). My LBS looked at it again, and the torque seemed to hold up. Given the cost of the wheels, I asked him to send them to Zipp for a review. Zipp said that the torque was slightly above spec. Since a couple spokes had shown the effects of the chain-jump event, and since the wheel is in its first year, they completely re-spoked and rebuilt the wheel to factory spec at no charge since they considered it to be under warranty. I was very pleased and excited to hear about what they did of their own volition. The wheel should be back at my LBS today. Can't wait to try it out. A very good ending to this story.
You are not authorized to post a reply.

Active Forums 4.1

Latest Forum Posts
Hey 79 posted in The Coffee Shop

2 years too late (Roman Kreuziger) posted in The Dark Side

PING: OC...What, no orange for LottoNL-Jumbo? posted in Professional Racing

cyclist door incidents article posted in Road Cycling

PING: Dale, 6ix and thinline posted in Road Cycling

Microshift posted in Gear Advice

Tour de France 2015 Winner Unveiled!! posted in Professional Racing

No articles match criteria.
  Terms and Conditions | Privacy Policy  Copyright 2008-2013 by VeloNation LLC